Juniper Netscreen команды




Полезная ссылка: О нас и наших клиентах

 

Команды на оборудовании Juniper Netscreen 

 

 

 

Interface

 

get counter statistics Show interface statistics (CRC errors etc)
get interface trust port phy Show physical ports for a certain zone
get driver phy Show all link states of interfaces
get counter statistics interface ethernet3 Show hardware stats on interface
set interface [interface] no-subnet-conflict-check  Allows you to configure multiple interfaces in the same IP broadcast domain.

 

 

Current Settings / Values

 

get envar get environment variable
get config get device configuration
get system get system information
get arp get arp cache
get route get routing table
get system | i Box get port-mode
get alg h323 counters get the ALG counters
get alg get status of ALGs (disabled or enabled)
get sys-cfg get default settings for the device
get sys scale get basic system limits
get debug get currently enabled debug level
get tcp  get system socket information

 

 

NAT

 

get mip get mip (nat)
get vip get vip (nat)
get nat cookie get show nat cookies

 

 

Statistics / Performance

 

get perf cpu detail  get cpu performance 
get session info get load on firewall  
get counter flow  Show flow stats (fragmentation etc)
get counter screen Show screen stats (SYN Floods etc)

 

 

VPN

/>

 

clear ike-cookie [gateway ip]  clear ike cookies
clear sa [id] 
clear sa
get vpn show vpns

 

 

NSRP

 

get nsrp cluster Show cluster info
get nsrp monitor Show list of monitored interfaces
get nsrp vsd id 0 Show VSD id 0
get counters ha Show HA interface hardware counters
exec nsrp sync global-config check-sum Allows you to see if the cluster configs are syncronised
exec nsrp sync global save Sync's the nodes.A reboot is required to complete the update.
exec nsrp vsd-group 0 mode Fails over the cluster. Run this command on the Master node.

 

 

IGMP

 

set interface ethernet0/1 igmp router enable IGMP on interface eth0/1
get vrouter trust-vr protocol pim get the multicast sources visible to your ScreenOS device

 

 

Misc

 

set exec port-mode set the port mode
set flow tcp-mss 1460 sets the MSS

 

 

Полезная ссылка: Консультация по настройке оборудования Juniper

 

 

 

 



Обновлен 12 июл 2014. Создан 26 фев 2014



  Комментарии       
Имя или Email


При указании email на него будут отправляться ответы
Как имя будет использована первая часть email до @
Сам email нигде не отображается!
Зарегистрируйтесь, чтобы писать под своим ником

____

______
Яндекс.Метрика